California Boiler

Jeremias Group

Jeremias Group Sales and Support from California Boiler

Home | Manufacturers | Jeremias Group

The Jeremias Group has more than 40 years of experience in flue and chimney production.

Jeremias Inc. manufactures:

  • Double wall and insulated conical pipe exhaust systems that use a unique steel surface to steel surface joint that is pressure and liquid tight without the need for silicone sealant. Models for single wall applications.
  • Boiler exhaust stack from 3” to 36”
  • UL Approved Grease Duct

DWKL

Double Wall Conical all-in-one chimney and exhaust system.

DWKL-Lt

Double Wall Lighting gauge inner Conical all-in-one chimney and exhaust system.

DWKL-Rx

Double Wall Conical all-in-one chimney and exhaust system.

DWKL-Vt

Double Wall Vent Conical all-in-one chimney and exhaust system.

Flue Gas Dampers

Flue gas dampers are installed in the connection pipe between a boiler and the chimney and close the flue gas path, if the chimney is no longer in use. The flow safeguard prevents the cooling down of the heat generator and the installation room, which helps to save energy. In addition, they prevent a possible influx of exhaust gases of other fireplaces connected with the chimney, for example in the cascade system and have the effect of an exhaust gas silencer if there are more than one fireplace connected with the chimney.

Stainless steel or black steel flue gas dampers made by Jeremias are used in combined heat and power plants, emergency power systems, exhaust air technologies and in overpressure operation engines.

Flue Gas Duct

Flue gas ducts are made for a robust and safe connection solution between the boiler-/engine outlet and the chimney entrance. Depending on the requirement of the service life and the different compression ratio, they can be produced as a plug –in system, completely welded or as a flange system. The planning in this sector for compensators, flue gas dampers, structural steel supports is done by our experienced project leaders. In this way it is possible to offer you professionalism, knowledge, and absolute guaranty.

FS-RM - Freestanding Chimney Systems

If you are looking for a flexible solution for your chimney the FS-RM system is the best system for you.  The combination of a steel (chimney) support mast and stainless steel chimney elements offers you the possibility to customize your chimney at any time as per your new requirements.  Hence it is now possible to achieve heights of up to 30 meters with stainless steel elements.

FSA - Freestanding Chimney Systems

Free-standing, double wall chimney with a supporting couter wall and a non-expanding inner pipe for exhaust gases.  The FSA system offers flexibility and large heights.

FSA-X - Freestanding Chimney Systems

In comparison to FSA, the FSA-X has multiple inner pipes.  The “X” stands for the number of inner pipes. This facilitates to connect two or more heat producers to the same outer chimney, hence economical.

FSB - Freestanding Chimney Systems

The FSB is a free-standing, insulated and cladded steel chimney with an inner static supporting flue gas line. This system is usually affixed with one or more brackets to a building.

SWKL

Single Wall Conical all-in-one chimney and exhaust system.

SWKL-Vt

Single Wall Conical Lighter gauge all-in-one chimney and exhaust system.

University of Rhode Island
This facilities operation was taken over by NORESCO and upgraded with new equipment. Steam is supplied throughout the entire campus. 

View more case studies